 |
isoPods - miniature amplifiers
eDAQ Pods and isoPods are our series of miniature amplifiers
isoPods™ are electrically isolated and can be used in situations where signal noise and crosstalk would otherwise be an issue.
e-corder isoPods
e-corder isoPods attach to the Pod ports on front panel of the e-corder unit. They become an extension of the e-corder system and are fully controlled by Chart or PowerChrom software.
 |
pH & ISE isoPod™ | for pH, ion selective, and ORP electrodes |
|
dO2 isoPod™ | a compact signal conditioner for monitoring polarographic (Clark) dissolved oxygen electrodes |
|
Bridge isoPod™ | full bridge amplifier providing DC or AC excitation |
|
Nitric Oxide isoPod™ | a compact, low noise, signal conditioner for monitoring polarographic nitric oxide electrodes |
|
Biosensor isoPod™ | for amperometric electrodes and sensors |
|
Conductivity isoPod™ | this isoPod is suitable for continuous monitoring of solution conductivity with a two electrode conductivity probe |
|
Thermocouple isoPod™ | an electrically isolated amplifier that is suitable for connection to most types of thermocouple probe |
|
RTD/Thermistor isoPod™ | suitable for use with the ET020 RTD, or ET021Thermistor temperature probes up to 125 °C. |
USB isoPods
USB isoPods attach directly to a computer USB port or to a USB hub. The isoPod requires a computer with a virtual COM port (VCP) driver from FTDI installed. You can write you own special pupose software using LabView, C++, etc to communicate with these isoPods, or use eDAQ Pod-Vu software to log and graph signals directly to a Windows XP or later computer.
When using more than four USB isoPods on the one computer a good quality powered USB hub is required (eg Belkin model F4U041 or similar).
|
pH/ISE isoPod™ with USB | for pH, ion selective, and ORP electrodes |
|
dO2 isoPod™ with USB | a compact signal conditioner for monitoring polarographic (Clark) dissolved oxygen electrodes |
|
Nitric Oxide isoPod™ with USB | a compact, low noise, signal conditioner for monitoring polarographic nitric oxide electrodes |
|
Biosensor isoPod™ with USB | for amperometric electrodes and sensors |
|
Thermocouple isoPod™ with USB | an electrically isolated amplifier that is suitable for connection to most types of thermocouple probe |
|
RTD/Thermistor isoPod™ with USB | suitable for use with the ET020 RTD, or ET021Thermistor temperature probes up to 125 °C. |
|
Conductivity isoPod™ with USB | this isoPod is suitable for continuous monitoring of solution conductivity with a two electrode conductivity probe |