Connecting the C4D to the PrinCE-C 600 and GPA100
From eDAQ Wiki
Revision as of 16:17, 8 July 2013 by Oliver (Talk | contribs) (Created page with "CE instrument connected to the C4D system [[File:DSC04095 edited.JPG|300px|thumb|right|The capillary exits through the right han...")
This application note describes how to connect the eDAQ C4D system to the Prince Technologies PrinCE-C 600 series and the Groton Biosystems GPA100 (previously sold as Crystal CE and Unicam CE instruments).
Introduction
The instrument can be used with a range of modular detectors, including UV/VIS, Fluorescence, LIF, MS, Photo Diode Array and the eDAQ C4D system.
Trigger Cable
The instrument can be configured to trigger the start of analysis of the contactless conductivity detector, with either PowerChrom or Chart software. This is achieved by connecting the “Marker output” at the back of the CE instrument to the e-corder or PowerChrom trigger input, using the relevant cable.