Difference between revisions of "Connecting the C4D to the PrinCE"

From eDAQ Wiki
Jump to: navigation, search
(Created page with "CE instrument connected to the C4D system [[File:DSC04095 edited.JPG|300px|thumb|right|The capillary exits through the right han...")
 
(One intermediate revision by the same user not shown)
Line 6: Line 6:
  
 
== Introduction ==
 
== Introduction ==
The instrument can be used with a range of modular detectors, including UV/VIS, Fluorescence, LIF, MS, Photo Diode Array and the eDAQ C4D system.
+
The instrument can be used with a range of modular detectors, including UV/VIS, Fluorescence, LIF, MS, Photo Diode Array and the eDAQ [https://www.edaq.com/c4d-contactless-conductivity-detector C4D system].
  
 
[[File:DSC04055.JPG|300px|thumb|right|Connectors at the back of the instrument]]
 
[[File:DSC04055.JPG|300px|thumb|right|Connectors at the back of the instrument]]

Revision as of 11:18, 31 May 2017

CE instrument connected to the C4D system
The capillary exits through the right hand panel of the instrument and passes through C4D headstage.


This application note describes how to connect the eDAQ C4D system to the Prince Technologies PrinCE-C 600 series and the Groton Biosystems GPA100 (previously sold as Crystal CE and Unicam CE instruments).

Introduction

The instrument can be used with a range of modular detectors, including UV/VIS, Fluorescence, LIF, MS, Photo Diode Array and the eDAQ C4D system.

Connectors at the back of the instrument

Trigger Cable

The instrument can be configured to trigger the start of analysis of the contactless conductivity detector, with either PowerChrom software or Chart software. This is achieved by connecting the “Marker output” at the back of the CE instrument to the e-corder or PowerChrom trigger input, using the relevant cable.

Citations

  • The PrinCE 500 instrument was used with the eDAQ C4D for the determination of creatine and phosphocreatine in muscle biopsy samples. The limits of detection for creatine and phosphocreatine were found to be 2.5 and 1.0 µM, respectively. It was noted that contactless conductivity detection allows the determination of molecules which are not accessible by UV-detection, and is therefore more versatile. It is also simpler, and thus less expensive, and has other advantages such as higher robustness as it is not necessary to create an optical window in the protective coating of the separation capillaries. DOI: 10.1016/j.aca.2012.03.055
  • Lipophilic Anions were extracted using Electric Field-Driven Extraction across a Carrier-Mediated Polymer Inclusion Membrane, separated using the PrinCE 500 instrument and detected using the eDAQ C4D. Limits of detection of 0.8 and 1.5ng/mL were obtained for glyphosate and aminomethylphosphonic acid respectively. DOI: 10.1021/ac201772g