Difference between revisions of "Frequently Asked Questions e-corders"
From eDAQ Wiki
(Created page with "__TOC__ This is where e-corder questions will be.") |
|||
Line 1: | Line 1: | ||
__TOC__ | __TOC__ | ||
− | + | === Why can I see steps in my data instead of getting smooth curves? === | |
+ | It is likely that you have chosen a recording range which is too big and you are seeing [https://www.edaq.com/wiki/Basics_of_Data_Acquisition#Digitization digitization]. If your peaks are only a few millivolts high, and you have left the default 10 volt range, you will see stepped peaks; the signal and areas will be inaccurate. You should select a recording range slightly higher than the largest signal you will record. Have a look at the [https://www.edaq.com/wiki/Basics_of_Data_Acquisition#Range basics of data acquisition] application note. |
Revision as of 17:09, 10 August 2017
Why can I see steps in my data instead of getting smooth curves?
It is likely that you have chosen a recording range which is too big and you are seeing digitization. If your peaks are only a few millivolts high, and you have left the default 10 volt range, you will see stepped peaks; the signal and areas will be inaccurate. You should select a recording range slightly higher than the largest signal you will record. Have a look at the basics of data acquisition application note.