|
|
| (5 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| − | [[File:DSC04090 edited.JPG|300px|thumb|right|CE instrument connected to the C4D system]]
| + | moved to C4D004 [[Connecting the C4D to the PrinCE]] |
| − | [[File:DSC04095 edited.JPG|300px|thumb|right|The capillary exits through the right hand panel of the instrument and passes through C4D headstage.]] | + | |
| − | | + | |
| − | | + | |
| − | ''This application note describes how to connect the eDAQ C4D system to the Prince Technologies PrinCE-C 600 series and the Groton Biosystems GPA100 (previously sold as Crystal CE and Unicam CE instruments).''
| + | |
| − | | + | |
| − | == Introduction ==
| + | |
| − | The instrument can be used with a range of modular detectors, including UV/VIS, Fluorescence, LIF, MS, Photo Diode Array and the eDAQ C4D system.
| + | |
| − | | + | |
| − | [[File:DSC04055.JPG|300px|thumb|right|Connectors at the back of the instrument]]
| + | |
| − | | + | |
| − | == Trigger Cable ==
| + | |
| − | The instrument can be configured to trigger the start of analysis of the contactless conductivity detector, with either [http://www.edaq.com/ES280 PowerChrom software] or [http://www.edaq.com/Chart Chart software]. This is achieved by connecting the “Marker output” at the back of the CE instrument to the e-corder or PowerChrom trigger input, using the relevant cable.
| + | |
Latest revision as of 23:29, 22 January 2014
moved to C4D004 Connecting the C4D to the PrinCE
