Difference between revisions of "Signal Sources and Amplifiers"

Revision as of 17:57, 13 September 2013

Introduction

In order to record an experimental signal with high fidelity 3 issues need to be considered.

• Signal Sources to be measured
• Characteristics of the signal sources
• Type of Amplifier used to record the signal

Signal Sources

There are 4 types or classes of electical signal sources which occur in various experimental situations. It is important to understand the characteristcs of these signal sources in order that they can be matched to the correct amplifier/recording system without degrading the accuracy of the measurement.

PLEASE NOTE: In discussing the characteristics of signal sources reference will be made to "Source Impedance" which in its most general form consists of a combination of 3 electrical elements: Resistance,Inductance and Capacitance. In most cases one of these elements will predominate, most commonly resistance. So when the term "Source Resistance" is used it implies that the impedance of the source is mainly resistive in nature. At DC or low frequencies source impedance is mainly resistive and the other elements, capacitance and inductance only come into play at higher frequencies.

http://en.wikipedia.org/wiki/Electrical_impedance

These 4 classes are listed and discussed below:

Single ended - Floating

Single Ended Floating signals are not electrically connected to ground. The signal appears between the two terminals of the signal source. This signal can either be a voltage source or a current source.

An ideal voltage Source has a near zero internal impedance. An accurate reading can only be obtained with a measuring circuit whose own internal resistance is much higher than the source resistance of the source. Voltmeters therefore need to have a high internal reistance - ideally infinite.

An ideal current Source has a near infinite internal impedance. In this case to measure the source current the measurement impedance should be very low. Ammeters therefore need to have a low internal resistance - ideally zero.

Here is a picture:

Examples of Single Ended Floating Battery - Voltage source - very low internal resistance pH cell - Voltage source - very high internal resistance Thermocouple - Voltage source - very low internal reistance

Solar cell - Current source - medium internal resistance Oxygen sensor- current source - high internal reisttance

Single ended - Grounded with Common mode voltage

blah blah blah

Balanced - Floating

blah blah blah

Balanced - Grounded with Common mode voltage

blah blah blah

Source Characteristics

• Source Impedance
• Source Voltage
• Source Frequency content

Amplifier types

• Single ended - Grounded
• Single ended - Isolated
• Balanced - Grounded
• Balanced - Isolated