Difference between revisions of "Connecting 3rd Party Potentiostats to the e-corder"

Revision as of 19:43, 30 May 2013

Figure 1. e-corder with PAR362

Figure 2. e-corder with Hokuto Denko potentiostat

Figure 3. e-corder with Pine AFRDE4

How the e-corder and EChem software can be used with 3rd party potentiostats.

eDAQ sells a range of potentiostats:

• ER466 Potentiostat / Galvanostat
• EA163 Potentiostat
• EA362 (two-channel high sensitivity potentiostat)
• EA164 (four-channel potentiostat)

The e-corder from eDAQ is a data recorder and waveform generator. It is compatible with many other brands and models of potentiostats.

Potentiostats suitable for use with the e-corder and EChem software should have an ‘external input’ (for the potential waveform signal) and analog ‘recorder’ outputs. This includes most analog potentiostats.

Even if the potentiostat does not have an ‘external input’, it can still be used with the e-corder to record signals; Just make sure the potentiostat has analog ‘recorder’ or ‘monitor’ outputs.

If your potentiostat is presently used with a conventional chart recorder, XY plotter, or oscilloscope, it will almost certainly be suitable for connection to e-corder.

The e-corder connects to potentiostats from the following manufacturers:

• AMEL
• BANK Elektronik
• BAS (Bioanalytical Systems)
• Cypress Systems
• EMS
• HEKA
• Hokuto Denko
• PINE Instruments
• Princeton Applied Research (was EG&G PAR)
• Radiometer
• Schlumberger
• Sycopel

For more information, please refer to the EChem software manual, available at www.edaq.com/locked/manuals.html: Chapter 3 describes how to connect the e-corder to a potentiostat and how to set up the EChem software. Chapter 8 presents specific examples of third party potentiostats compatible with the e-corder.